Sign in or Apply for an Account

Aftermarket Auto Parts & Supplies
1-800-528-4400   Se Habla Español

IDENTIFYING A 2006-2007 JEEP LIBERTY REGULATOR


Because there were 2 types of window regulators installed in the 2006-2007 Jeep Liberty it is important that you identify the window regulator in your Liberty before you order. This will ensure that we will get you the correct part to repair your broken window quickly.

While it is possible to determine which window regulator you may have based on your Liberty's build date, in our experience we have found that a visual inspection is the most accurate way to determine which type of regulator you have.

Below are pictures of the regulator and glass inside the door shell. You will not need to remove them at this time but , you will need to remove the door panel, moisture shield and speaker (rear door only) to see the type of mount your regulator has.

You may see this sticker on your door jamb if your 2006 or 2007 vehicle has had Technical Service Bulletin 23-014-08 or Technical Service Bulletin 23-008-09 performed previously for a faulty regulator, the regulator and glass have been replaced with the Clip Mount type.

A visual inspection is still recommended.

**The 2002-2005 Jeep Liberty does not apply since they all used the Clip Mount regulator but an inspection will be necessary if your Liberty has been in a collision and a door was replaced with a used part.**


FRONT AND REAR - CLIP MOUNT TYPE

 

FRONT CLIP MOUNT TYPE
Use part # 2557-0001L/R

REAR CLIP MOUNT TYPE
WITH SPEAKER REMOVED
Use part # 2557-0002L/R

 

On the Clip Mount type regulator, the glass has a metal bracket attached to it on the bottom that will have studs, 2 for the front regulator and 1 for the rear, which allow it to be secured to the regulator glass guide with clips.

This style glass/regulator combination was used on all 2002-2005 vehicles and 2006 models built before 3/16/06 [we recommend that if you have a 2006 model you perform the visual check regardless of the build date because we have found some reference material where the change occurs as early as 5/2/05 and as late as 2007 models]. This is also the regulator and glass used to replace defective units under Technical Service Bulletins 23-014-08 or 23-008-09.


FRONT AND REAR - HOLE MOUNT TYPE

 

FRONT HOLE MOUNT TYPE
Use part # 2557-0003L/R

REAR HOLE MOUNT TYPE
WITH SPEAKER REMOVED
Use part # 2557-0004L/R

 

On the Hole Mount type regulator, the glass WILL NOT have a metal bracket on the bottom. Instead it has a hole in it that the regulator glass guide snaps into.

or Open an Account
© 2017 Brock Supply Co., 2150 E. Rio Salado Pkwy, Tempe, AZ 85281
Privacy Policy   |   Terms of Use